Aluminium conductor — copper-equivalent cross-section
A comparison of current-carrying capacity between aluminium and copper conductors under the same installation method: because of aluminium's lower conductivity (roughly 61% of copper), an aluminium cross-section about 1.5-1.6× larger than the equivalent copper cross-section is needed for the same ampacity (e.g. 25 mm² Al is roughly equivalent to 16 mm² Cu). Aluminium is mainly used for large cross-sections (main cables, grid connections) due to its lower weight and cost; terminations require special aluminium-rated clamps/joint compound to prevent galvanic corrosion and creep.
Voor de ondergrondse hoofdkabel van 150 m naar een nieuw bedrijfspand kiest de installateur een aluminium kabel van 95 mm² in plaats van 63 mm² koper, wat qua belastbaarheid gelijkwaardig is maar aanzienlijk lichter en goedkoper.
Een aluminium geleider aansluiten met een klem of lasdop die alleen voor koper is goedgekeurd — dit veroorzaakt galvanische corrosie en kruip van het zachte aluminium, met een oplopende overgangsweerstand en brandgevaar tot gevolg.
See also
- → §543.4 (IEC 60364-5-54) §543.4 — The PEN conductor: minimum cross-section and the switching prohibition
- → §523 Cable cross-section & current-carrying capacity
- → §412 / IEC 60364-4-41 §412 — Basic protection against direct contact, IP2X and the jointed test finger
- → §413.3 Electrical separation (§413.3) — an isolating transformer as a protective measure without earthing
- → §706 Conductive locations with restricted movement (§706) — working inside tanks and boilers
- → §542 / IEC 60364-5-54 Sizing an earth electrode — the calculation formulas for rod and plate electrodes